Help Centre
Help Centre Troubleshooting Why won't my V1CE card tap? (NFC troubleshooting)

Why won't my V1CE card tap? (NFC troubleshooting)

Published 19 June 2026 Updated 12 November 2026 Reviewed 12 November 2026 Troubleshooting

If your V1CE card opens your page by QR scan but nothing happens on a tap, the card is working. Tap and scan use different hardware. Hold the card flat against the phone, check NFC is on for Android, and contact V1CE support if it still fails.

Time needed3 minutes
What you needYour card and a phone with NFC
Where in the appYour phone

Tapping uses the NFC chip and scanning uses the QR code. A card can scan perfectly and still need a better tap technique. Work through these steps.

Try these first

  • Scan the QR code on the back. If your page opens, the card and page are working.
  • Unlock the phone and remove any thick or metal case.
  • Hold the card still against the phone for a second or two.

Steps to fix a card that will not tap

Step 1: Tap, do not scan

NFC is the tap. Touch the card to the phone. Do not point the camera at it.

Step 2: Metal cards: use the back

On a metal card, the NFC signal comes from the back, the side opposite the design. Hold the back flat to the phone.

Step 3: iPhone

Make sure the screen is on and unlocked. Hold the card to the top edge of the phone, near the front camera. A banner appears at the top. Tap it to open your page. iPhone NFC is always on.

Step 4: Android

Turn NFC on in Settings by searching for NFC. Hold the card to the back of the phone, start in the middle, then move slowly up and down until it reads.

Step 5: Try again without a case

Case thickness or metal plates can block the signal.

If the QR code does not open your page

That points to the card link rather than tap technique. See the guides on activating your card and on a card that opens the wrong page.

Still not tapping?

If the QR scan works, NFC is on and the tap still does nothing, send V1CE support a short video of what happens when you tap. If the card is faulty, V1CE will reprint and ship a replacement at no extra cost.

Still stuck? Contact V1CE support with a short video of the tap.

Good to know

  • The QR code works as a backup, so sharing is never blocked.
  • Android antenna positions vary, so move the card around the back of the phone.

Frequently asked questions

Why does my QR code work but not the tap?

They use different hardware. The card is fine, and tap technique or phone NFC settings are the likely cause.

Where do I hold a metal card?

Hold the back of the card, opposite the design, flat against the phone.

Where is the NFC reader on an iPhone?

At the top edge, near the front camera. Keep the screen on and unlocked.

Do I need to switch NFC on?

On Android, yes, in Settings. iPhone NFC is always on.

What if my card is faulty?

Send V1CE support a short video of the tap. If it is faulty, V1CE reprints and ships a replacement at no extra cost.

Does a phone case matter?

Thick, metal or card holder cases can block the tap. Try without the case.

Was this helpful?